StepOne

In beta testing

Shop software that draws what you meant.

Two Windows programs for cabinet and countertop shops. One drafts, one designs and prices. Both run real jobs inside a working countertop business.

StepOne Cabinet Designer StepOne CAD
A kitchen plan being drafted A 264 inch run of nine cabinets and appliances along a wall, a 108 inch island 42 inches in front of it, countertops over both, and dimension chains above and below. B36 SB36 DW24 B30 RANGE30 DB30 B24 REF36 UP18 B15 B15 B15 B15 B15 B15 B18 264" 36"36" 24"30" 30"30" 24"36" 18" 108" 42"
A kitchen run, its countertop and its dimension chains, drawn for this page. The real screenshots are below.

StepOne Cabinet Designer

Replaces 2020 Design for kitchen and bath

Draw the walls, drop the cabinets, and the run prices itself as you go. The 3D is not a render you wait for. It is the same design seen from inside the room, one click from the plan you were just editing.

A real kitchen, 34 priced items, in the 3D view, with the catalog on the left and the priced item list on the right. Same design as the plan, one click away, no export step.
  • DesignWalls by length and angle, doors and windows, a searchable catalog, snapping that holds where you put it
  • Views2D plan, 3D, elevations and measure. The same job, four ways
  • PricingA live priced item list beside the drawing, with moldings counted by the run
  • OutputA multi-sheet drawing set, printed or saved to PDF, plus a shareable 3D link

Switch between the plan and the 3D

StepOne CAD

Replaces AutoCAD for countertop drafting

A 2D drafting program that speaks DXF as its native tongue. The point is not that it draws. The point is that what your stone partner opens on their machine is the drawing you sent. A filleted top written here opens in AutoCAD looking the same, and comes back as the same drawing.

Three tops from one job: an edge note on every side, R¾" call-outs at the corners, and 73 29/32" stacked the way AutoCAD stacks it.
  • DrawingLine, polyline, arc, circle, ellipse, fillet and chamfer, offset, trim, extend, array, boundary
  • DimensionsAligned, linear, ordinate, radius, diameter, angular and jogged, with fractions stacked the way AutoCAD stacks them
  • FilesReads four DXF dialects, writes AC1032. 2D only, by design
  • PrintingPrints at exact scale. A rule on the paper gives back the number on the drawing

See how the round trip is proved

Built in a shop, not in a boardroom.

Both programs started as things that were needed on a Tuesday. The countertop business behind them was paying for drafting software that fought back, and quoting software priced like a second employee.

So the standard they are held to is not a feature list. It is whether a real job goes out the door correctly, and each program carries its own checks to prove it.

  1. 8real shipped drawings, read and written back on every test run of StepOne CAD
  2. 7,613values cross-checked between two independent implementations of the same arithmetic
  3. 4DXF dialects read, AC1009 through AC1032
  4. 244automated checks in StepOne Cabinet Designer, each written for a bug that really happened

Both programs are in beta testing.

If you would like to participate in beta testing, send an email to support@provision.services.

Email support@provision.services